12-inch RV Pigtail Propane Hose QCC1 Connector and a 1/4 Inverted Male Flare
0.00
Regular price
$20.79
Regular price
Save 16%
$24.74
Sale price
$20.79
Fast Delivery
Delivery options available at checkout
30 Day Returns
Return Policy
CONFIRM THIS PART FITS
Enter appliance or equipment model number to verify compatibility with this part
Replaces Part Numbers
12-inch RV Pigtail Propane Hose QCC1 Connector and a 1/4 Inverted Male Flare
Key Features
- Length: 12 inches
- Hose Material: Thermo-plastic rubber or braided stainless steel
- Inlet Connector: QCC1 (Type 1) nut for hand-tightening on 20 lb and 30 lb propane cylinders
- Outlet Connector: 1/4 inch inverted male flare
- Maximum Working Pressure: 350 PSI
- Safety: Integrated excess flow protection and thermal shut-off device
Replaces / Cross-Reference Part Numbers
- Replaces cracked, leaking, or age-damaged 12-inch pigtail hoses with identical QCC1 and 1/4 inch inverted male flare fittings.
- Direct replacement for pigtail hoses used on many automatic changeover two-stage regulators.
Compatibility & Fitment
- Connects standard 20 lb and 30 lb DOT propane cylinders to RV or trailer two-stage regulators.
- Fits regulators and four-port brass tees that require a 1/4 inch inverted male flare inlet.
- Commonly used for dual propane tank setups on travel trailers, fifth wheels, and campers.
When to Replace
- Visible signs of wear such as cracks, brittleness, cuts, or abrasions on the hose.
- Leaking gas detected by smell or a soapy water test at the connection points or along the hose body.
- Corrosion on brass fittings that prevents a secure, leak-free seal.
- As part of periodic maintenance, typically every 5 to 7 years, regardless of appearance.
Installation Tips
- Ensure the propane cylinder valve is fully closed before starting removal or installation.
- Hand-tighten the QCC1 nut onto the propane cylinder valve; do not use tools on this plastic fitting.
- Use appropriate wrenches to tighten the 1/4 inch inverted flare fitting onto the regulator or tee. Use a second wrench to hold the regulator inlet fitting to prevent damage.
- After installation is complete, open the cylinder valve slowly and check all connections for leaks using a non-corrosive gas leak detector solution.
- Route the hose to prevent kinking, sharp bends, and contact with sharp edges or sources of high heat.
Suggestions
Common Model Number Locations
Need help finding your model number? Select your appliance or lawn equipment below for location diagrams
- Above the refrigerant valves on the back of the air conditioner
- On the side of the unit near the run capacitor or electrical lines that go into your home
- On either side of the exterior
- On the back of the unit where the power cord is located
- In the cool air exhaust port
- To the left of the fan opening, on the weather barrier
- Below the control panel
- On either side of the exterior
- Behind the front grill on the frame
- On the door frame
- On the inside of the tub wall
- Behind the control panel
- On the door
- Inside the edge of the unit
- On the back exterior
- On the door
- On the side of hose storage
- Inside the edge of the unit
- On inside of the door
- On the door frame
- On the back exterior of the unit
- On the exterior side of the unit
- Behind the control panel
- On the inside of the door
- On the door frame
- On the exterior side of the unit
- At the top of the unit
- On the inside of the dryer door
- On the door frame
- Under the washer lid
- On either side of the exterior
- On the back exterior of the unit
- On the door frame
- On the exterior side of the unit
- On interior wall
- On the control panel
- On side of door
- On the right-hand side of the vent, under the control panel
- On the interior wall of the microwave (microwave model number only)
- On the door frame
- On the rear panel
- On the exterior back of the unit
- Inside the top part of the vent duct (in down-draft models)
- Underneath a burner
- Underneath a knob
- Underneath the cooktop (lift-up style)
- Bottom of cooktop
- On an exterior wall
- On an inside wall
- On the door frame
- On the right-hand side of the vent, under the control panel
- On the interior wall of the microwave (microwave model number only)
- On the door frame
- On the rear panel
- Behind the control panel
- Under the front surface unit
- On the door frame
- Interior side panel
- On the exterior of the unit
- On the inside of the lower storage compartment wall
- On top the hood
- Behind the filter
- Under the hood
- On the inside of the door
- On the exterior back of the unit
- Inside on the rear wall
- On the exterior side of the unit
- On door jamb
- On rear of frame
- Behind front panel
- On ceiling of refrigerator
- On interior wall
- On the inside of the door
- Behind crisper drawer
- Behind kickplate
- On ceiling of refrigerator
- On interior wall
- On door frame
- Behind crisper drawer
- Behind kickplate
- On ceiling of freezer
- On interior wall
- On the inside of the door
- Behind kickplate
- On the exterior side of the unit
- On inside of the door
- On the door frame
- On the back exterior of the unit
- On the front exterior of the unit
- On the control panel
- Inside the lid
- Under the lid on the frame
- On the exterior of the unit
- At the top of the unit
- On the inside of the dryer door
- On the door frame
- Under the washer lid
- On either side of the exterior
- On the top center of heater
- On the exterior of the unit
- On the starter housing
- On the side of the housing, behind the top handle
- On the side of the motor housing
- Near the rear grip
- On the top or sides of the engine housing
- On the gas tank
- On the recoil housing
- On the handle bars
- On top of the engine cover
- Near discharge chute, often behind chute flaps
- On rear of the deck, behind the engine
- Dash panel
- Back of mower/rear bumper
- Underside of the seat
- Lower side of hood, near engine
- Frame (beneath the seat, footrest)
- Mower deck
- Underside of the seat
- Frame beneath or near the seat
- Back of mower/rear bumper
- Lower left side between gas tank and mower deck
- Under the foot plate
- On the rear of the blower
- Inside of vacuum canister
- Side of the motor housing
- On the rear base of the vacuum
- On the bottom of the belly of the vacuum
- On the frame near the engine
- On the side of the auger housing
- On the lower rear of the snow blower between wheels
- On the side of the motor housing
- On the shaft
Select an appliance to see where its model number is located.
