W10131825 Oven Temperature Sensor - For Whirlpool Maytag KitchenAid Ovens
0.00
Regular price
$22.82
Regular price
Save 13%
$26.24
Sale price
$22.82
Fast Delivery
Delivery options available at checkout
30 Day Returns
Return Policy
CONFIRM THIS PART FITS
Enter appliance or equipment model number to verify compatibility with this part
W10131825 Oven Temperature Sensor Replacement
Key Features
- Accurately detects and communicates internal oven temperatures to the control board for consistent thermal regulation.
- Constructed with a high-grade stainless steel probe to ensure thermal conductivity and corrosion resistance.
- Equipped with a standardized 2-pin quick-connect wiring harness for efficient electrical termination.
- Precision-calibrated to provide a resistance of approximately 1080–1100 ohms at room temperature (approx. 70°F).
Replaces / Cross-Reference Part Numbers
- WPW10131825
- AP6015486
- PS11748765
- 4455636
- 1449853
- WPW10131825VP
- EAP11748765
- AWP49235
Compatibility & Fitment
- Compatible with Whirlpool, Maytag, KitchenAid, Jenn-Air, and Amana ranges and ovens.
- Fits built-in wall ovens, freestanding electric ranges, and gas convection models.
- Designed for use in both upper and lower oven cavities in double-oven configurations.
When to Replace
- Appliance displays temperature-related error codes (e.g., F3, F3-E0, F3-E1, or F3-E2).
- Oven fails to reach the set temperature or significantly overshoots the desired heat level.
- Baking or roasting results are inconsistent, leading to unevenly cooked or burnt food.
- Oven does not heat at all despite the display and controls appearing functional.
- Multimeter testing reveals the sensor is "open" (no continuity) or provides readings outside the 1000–1200 ohm range.
Installation Tips
- Ensure the appliance is disconnected from the power source (unplugged or breaker tripped) before beginning.
- Remove oven racks to provide clear access to the rear of the oven cavity.
- Use a 1/4-inch nut driver or hex head wrench to remove the two screws mounting the sensor to the back wall.
- Pull the sensor and its wiring harness forward until the plastic connector is visible; if it does not pull through, access the connector via the rear panel of the range.
- Depress the locking tab on the connector to release the old sensor and snap the new unit into place.
- Re-insert the wiring into the insulation hole and secure the probe flush against the wall with the mounting screws.
Suggestions
Common Model Number Locations
Need help finding your model number? Select your appliance or lawn equipment below for location diagrams
- Above the refrigerant valves on the back of the air conditioner
- On the side of the unit near the run capacitor or electrical lines that go into your home
- On either side of the exterior
- On the back of the unit where the power cord is located
- In the cool air exhaust port
- To the left of the fan opening, on the weather barrier
- Below the control panel
- On either side of the exterior
- Behind the front grill on the frame
- On the door frame
- On the inside of the tub wall
- Behind the control panel
- On the door
- Inside the edge of the unit
- On the back exterior
- On the door
- On the side of hose storage
- Inside the edge of the unit
- On inside of the door
- On the door frame
- On the back exterior of the unit
- On the exterior side of the unit
- Behind the control panel
- On the inside of the door
- On the door frame
- On the exterior side of the unit
- At the top of the unit
- On the inside of the dryer door
- On the door frame
- Under the washer lid
- On either side of the exterior
- On the back exterior of the unit
- On the door frame
- On the exterior side of the unit
- On interior wall
- On the control panel
- On side of door
- On the right-hand side of the vent, under the control panel
- On the interior wall of the microwave (microwave model number only)
- On the door frame
- On the rear panel
- On the exterior back of the unit
- Inside the top part of the vent duct (in down-draft models)
- Underneath a burner
- Underneath a knob
- Underneath the cooktop (lift-up style)
- Bottom of cooktop
- On an exterior wall
- On an inside wall
- On the door frame
- On the right-hand side of the vent, under the control panel
- On the interior wall of the microwave (microwave model number only)
- On the door frame
- On the rear panel
- Behind the control panel
- Under the front surface unit
- On the door frame
- Interior side panel
- On the exterior of the unit
- On the inside of the lower storage compartment wall
- On top the hood
- Behind the filter
- Under the hood
- On the inside of the door
- On the exterior back of the unit
- Inside on the rear wall
- On the exterior side of the unit
- On door jamb
- On rear of frame
- Behind front panel
- On ceiling of refrigerator
- On interior wall
- On the inside of the door
- Behind crisper drawer
- Behind kickplate
- On ceiling of refrigerator
- On interior wall
- On door frame
- Behind crisper drawer
- Behind kickplate
- On ceiling of freezer
- On interior wall
- On the inside of the door
- Behind kickplate
- On the exterior side of the unit
- On inside of the door
- On the door frame
- On the back exterior of the unit
- On the front exterior of the unit
- On the control panel
- Inside the lid
- Under the lid on the frame
- On the exterior of the unit
- At the top of the unit
- On the inside of the dryer door
- On the door frame
- Under the washer lid
- On either side of the exterior
- On the top center of heater
- On the exterior of the unit
- On the starter housing
- On the side of the housing, behind the top handle
- On the side of the motor housing
- Near the rear grip
- On the top or sides of the engine housing
- On the gas tank
- On the recoil housing
- On the handle bars
- On top of the engine cover
- Near discharge chute, often behind chute flaps
- On rear of the deck, behind the engine
- Dash panel
- Back of mower/rear bumper
- Underside of the seat
- Lower side of hood, near engine
- Frame (beneath the seat, footrest)
- Mower deck
- Underside of the seat
- Frame beneath or near the seat
- Back of mower/rear bumper
- Lower left side between gas tank and mower deck
- Under the foot plate
- On the rear of the blower
- Inside of vacuum canister
- Side of the motor housing
- On the rear base of the vacuum
- On the bottom of the belly of the vacuum
- On the frame near the engine
- On the side of the auger housing
- On the lower rear of the snow blower between wheels
- On the side of the motor housing
- On the shaft
Select an appliance to see where its model number is located.
